In actual work, if we encounter the problem of CNC compound grinder crawling, how should we deal with it? The reason is mainly due to the bad lubrication of the running rail of the worktable. If the lubrication is not enough or lubricant channel is blocked, the lubricating oil is simply no way to achieve the above rail, so it cannot achieve lubrication nursing.
So in the actual work, friction of the guide rail without lubrication will be significantly increased during operation, causing the crawling phenomenon of CNC composite grinding machine. For this situation, we need to timely check the specific lubrication, and to properly adjust the amount of lubrication, then crawling problem has been solved. What need to be attention is that the amount of lubricating adjustment between guide rails can not be too large, otherwise it will cause a shift occurred during the operation of the worktable, the processing quality of the work piece may even be affected finally.
Therefore, in the actual operation process, we need to master the specific operation skills, and do appropriate adjustment according to the requirements. In the process of using CNC composite grinding machine, the staff also need proper maintenance, to ensure that it can run stably for a long time.
First of all, during the use of CNC grinding machine, the operation time should be strictly controled , after a long time of continuous use, the equipment should be promptly shut down to rest for a while. Secondly, attention should be paid to the proper temperature condition in use. If the temperature is too low, the use should be stopped. If the weather conditions are humid, it is better to put a pack of moisture proof agent inside the screen.
Finally, in the process of using CNC composite grinding machine, we should pay attention to take corresponding protective measures, we must not impose too much pressure on its surface. If there is dirt on the surface of CNC composite grinding machine screen, it should be cleaned up in time.